Omron KM50 Communications Manual page 39

Section 2 CompoWay/F Communications Protocol
(3) Operation Commands and Precautions
● Reset Total Power Consumption
The total power consumptions are reset to 0.
The consumptions are totaled again as soon as they are reset.
● Go to Measurement Mode
The Power Monitor is changed to Measurement Mode.
When moving to Measurement Mode, the Power Monitor saves changes to settings to
EEPROM and is reset. After being reset, the Power Monitor operates with the new
settings.
● Go to Operation Setting Mode
The Power Monitor is changed to Operation Setting Mode.
Change to this mode before changing any parameters.
● Go to Protection Setting Mode
The Power Monitor is changed to Protection Setting Mode.
● Initialize Measurement Log
All measurement log data is initialized.
● Initialize Settings
All parameters are returned to the default settings.
● Initialize Professional Level
The measurement values for the day in the Professional Level of Measurement Mode are
initialized.
● Initialize All
All of the following are initialized: total power consumptions, measurement log, settings,
and Professional Level.
● Reset Maximum/Minimum
The maximum and minimum measurement values are reset.
Reset Maximum: The maximum values are reset to 0 (the minimum value).
Reset Minimum:
● Reset Software
The CPU is reset and the Power Monitor enters the same status as when it is turned ON.
No response is returned for this operation command (there is no service response PDU).
2-20
The minimum values are reset to the maximum values for the
currently selected VT or CT (type and ratio).