Omron KM50 Communications Manual page 114

*6: The pulse input counts are counter values that are reset on a daily basis. The total pulse
input count is not reset on a daily basis, rather it is reset to zero when the count upper limit is
reached, and starts counting again. Counter 1 and counter 2 are individual count values that
can be read separately. The total counter reads the sum of counter 1 and counter 2. A
summary is shown in the following table.
Parameter
Pulse Input Count 1 for the Day
Pulse Input Count 2 for the Day
Total Pulse Input Count for the Day
Total Pulse Input Count 1
Total Pulse Input Count 2
Sum Total Pulse Input Count
*7: Measurement Values after Recovering from a Power Interruption
The following measurement values are saved to the memory for every five-minute period.
Therefore, when the power supply is turned ON, the last value that was saved for a
five-minute period while the Power Monitor was ON will be read out, rather than the value
right before the power was interrupted. The measurement will continue.
Total power consumptions, pulse input ON time, pulse input count, specific power
consumption, and three-state total power consumptions
*8: Digits That Are Read Out
The upper digits and lower digits of a converted value can be read out separated. However,
there are only seven significant digits when the upper and lower digits are combined.
Read out value
Input count for input 1
Input count for input 2
Sum of input counts for inputs
1 and 2
Input count for input 1
Input count for input 2
Sum of input counts for inputs
1 and 2
5. 1 Variable Area
Reset
condition
Reset on a
daily basis.
Reset when
upper limit is
reached.
5-7