Pc Mode - R&S TSMA6 User Manual

®
R&S TSMA6
Prerequisites:
●
R&S TSMA6-ROMES software package
(TSMA6-ROMES-setup-<version>.exe) has to be installed on the
R&S TSMA6.
●
A ROMES license dongle must be connected to a USB port of the R&S TSMA6.
Import of ROMES Workspace File
Importing of the R&S ROMES workspace file is an additional requirement for operating
in the "ROMES" mode.
1. Start the R&S TSMA6 Web-GUI (see
GUI",
2. Navigate to "File Transfer" menu and go to section "Upload File to TSMA".
3. Press the "Browse" button, select the desired ROMES workspace file on the
remote PC and click "Upload File".
4. The file is copied by default in the directory
C:\ProgramData\Rohde&Schwarz\My ROMES\Workspace.
Note: The target directory for file upload depends on the selected mode. The men-
tioned directory is only valid in ROMES mode.
Measurement
To use the "ROMES" mode, the following steps must be performed.
1. In the Web-GUI, change the "Mode of Operation" to "ROMES" (see
"Measurement
2. Configure the following settings.
●
●
●
3. Click "Submit" to save your selection.
For more details about the R&S
documentation for R&S

6.3.5 PC Mode

The "PC Mode" is used for software update of the R&S TSMA6.
User Manual 4900.8057.02 ─ 01
on page 24).
Setup", on page 27).
Workspace File
In the drop-down menu, select a ROMES workspace file.
Recording
Activating this checkbox, the ROMES measurement data are written to the
TSMA6 hard disk.
IP Controlled
Activating this checkbox, the ROMES measurement can be controlled via IP
from an external host PC. To use this feature, the ROMES option
ROMES4RCO is required.
®
ROMES.
Chapter 6.1.1, "Start the R&S TSMA6 Web-
®
ROMES configuration and usage, refer to the user
Configuring the R&S TSMA6
Measurement Modes
Chapter 6.2,
34