Remote Installation - R&S TSMA6 User Manual

®
R&S TSMA6
The Web-GUI status changes to Installation complete - System is rebooting...
6. Setup is finished when the [State] LED stops blinking blue and changes to constant
green or blue, depending on the WLAN AP setting.
The Web-GUI status changes to No error.
If a restart is performed during the setup, the message System is Restarting is dis-
played in the status bar. For a short time, the Web-GUI is not accessible.
Do not interrupt the browser session on the remote PC. After an successful update, the
Web-GUI will be refreshed.

7.1.2 Remote Installation

The device must be in the PC Mode. Check it via the Web-GUI ("Overview" > "Mode of
Operation").
To change the operation mode, see
The setup files will be executed on a remote PC. In this case, the remote PC and the
R&S TSMA6 must be connected via LAN or WLAN.
1. Execute the setup file on the remote PC.
2. The "R&S Software Distributor" comes up. Select "Remote Installation" and press
"Next >".
User Manual 4900.8057.02 ─ 01
"Mode of Operation" on page 74).
Update and Restore
Installation Overview
40