Pc Mode; Remote Vicom Server Mode - R&S TSMA6 Series User Manual

®
R&S TSMA6
The "rViCom" and"PC Mode" are selectable on all the R&S TSMA6s. The other modes
(NESTOR, ROMES, QualiPoc) are only selectable if the appropriate SW applications
are installed (see

6.3.1 PC Mode

The "PC Mode" is the standard mode for installation of software and for the interactive
operation of the R&S TSMA6. In this mode, no software application (NESTOR,
ROMES, QualiPoc) is started in the background.

6.3.2 Remote ViCom Server Mode

This mode starts the Remote ViCom Server on the R&S TSMA6. Measurement config-
uration and data collection are controlled from a remote connected handheld device. A
Remote ViCom client application needs to be installed on the handheld device for this
purpose.
The connection between the Remote ViCom server on the R&S TSMA6 and the client
application (Remote ViCom client) on the handheld device can be realized via Blue-
tooth
The selection of the wireless interface type depends on the measurement task.
The WLAN connection allows a data throughput, which is about 10 times higher com-
pared to Bluetooth
The Bluetooth
Prerequisites
●
Bluetooth connection only
See
●
WLAN connection only
Connect the tablet/smartphone with the R&S TSMA6 WLAN AP. See
"Connecting with R&S TSMA6 WLAN Access
Measurement with the rViCom Sample App
To run measurements, the requirements for operating the rViCom Sample App have to
be fulfilled, see
1. Activate the rViCom server mode (see
Mode",
2. Start one of the following applications.
a) Start the OEM rViCom client application on the mobile device.
User Manual 4900.8057.02 ─ 06
Chapter 7.2, "Software
®
or WLAN.
®
.
®
connection is less influenced by radio interference.
Chapter 6.5, "Bluetooth
Chapter B, "Introduction to Remote ViCom Sample
on page 35).
Installation", on page 65).
®
Pairing", on page 43.
Point",
Chapter 6.2, "Selecting Measurement
Configuring the R&S TSMA6
Measurement Modes
Chapter 5.5,
on page 26.
App", on page 135.
36