Nestor And Nestor Probe Mode - R&S TSMA6 User Manual

®
R&S TSMA6
Figure 6-8: Scanner ready
For more details about the QualiPoc configuration and usage, refer to the user docu-
mentation for QualiPoc

6.3.3 NESTOR and NESTOR Probe Mode

The "NESTOR" mode is only selectable if the R&S NESTOR software is installed on
the R&S TSMA6.
In this mode, the NESTOR application is hosted on the R&S TSMA6.
In the "NESTOR Probe" mode, the NESTOR application is hosted on the
R&S TSMA6. Configuration and control of the NESTOR measurement is done on a
distant PC, which is connected via LAN/WLAN to the R&S TSMA6.
To use the R&S TSMA6 in "NESTOR" mode, the following steps must be performed.
Prerequisites:
●
R&S TSMA6-NESTOR software package must be installed on the R&S TSMA6.
The software package is pre-installed at delivery when the R&S TSMA6 is ordered
with NESTOR TSMA6 Option. (R&S No. 1522.8870.03).
Note: The R&S
to shipment.
Only for NESTOR mode
A dongle containing a smart card with R&S NESTOR option licenses must be availa-
ble.
Import of NESTOR Workspace File
Importing of the R&S NESTOR workspace file is an additional requirement for operat-
ing in the "NESTOR" mode.
1. Start the R&S TSMA6 Web-GUI from the host PC (see
R&S TSMA6
2. Select the "NESTOR" Mode with default workspace.
3. Navigate to "File Transfer" menu and go to section "Upload File to TSMA".
User Manual 4900.8057.02 ─ 01
®
.
®
NESTOR software installation can be executed as a post process
Web-GUI", on page 24).
Configuring the R&S TSMA6
Measurement Modes
Chapter 6.1.1, "Start the
32