User Backup And Restore; Backup; Restore - R&S TSMA6 User Manual

®
R&S TSMA6
1. Start the Web-GUI of the R&S TSMA6.
2. Select the ROMES option<serial number>.dat file in the field "Install
ROMES Options" and click "Install".

7.5 User Backup and Restore

7.5.1 Backup

In order to create a user backup, click the "User Backup" button in the Web-GUI "(Sys-
tem" > "Config" Tab), see
tem partition C:\ is created.
In case of an already existing user backup an acknowledgment dialog will pop up. After
confirmation this user backup will be overwritten.
The backup procedure takes up to 15 minutes.
During the backup the [State] LED is blinking red. In the Web-GUI, the following status
message will be displayed.
Backup is in progress...
The backup procedure has finished, when the [State] LED displays the normal operat-
ing state. The color of the depends on the state of the WLAN AP.
During the backup, do not interrupt the procedure or disconnect the power supply!

7.5.2 Restore

With the RESTORE button it is possible to restore the system partition R&S TSMA6 to
the user backup (see
no user backup exists.
In order to perform a restore, the RESTORE button must be pressed (more than 20 s)
with a round, blunt pen (diameter 1-2 mm). During the restore the [State] LED is blink-
ing red.
When the RESTORE procedure has been completed, the color of the [State] LED
depends on the state of the WLAN AP.
[State] LED
green
blue
User Manual 4900.8057.02 ─ 01
"Backup TSMA6 System"
Chapter 7.5.1, "Backup",
WLAN AP Status
WLAN AP off
WLAN AP on
Update and Restore
User Backup and Restore
on page 82. A backup of the sys-
on page 47) or to the factory backup, if
47