Romes Mode - R&S TSMA6 User Manual

®
R&S TSMA6
4. Press the "Browse" button, select the desired workspace file on the remote PC and
click "Upload File".
The file is copied in the directory
D:\Users\Instrument\Documents\NESTOR\FavoriteWorkspaces.
Note: The target directory for file upload depends on the selected mode. The men-
tioned directory is only valid in NESTOR mode.
The file is available from the "Configuration" > "System" > "Operation Mode" >
"NESTOR" workspace select-box.
Only for NESTOR Probe mode
The R&S TSMA6 and the external PC must be connected via WLAN or the LAN port of
the R&S TSMA6.
Measurement
To use the "NESTOR" or "NESTOR Probe" mode, the following steps must be per-
formed.
1. In the Web-GUI, change the "Mode of Operation" to "NESTOR" or "NESTOR
Probe" (see
2. According to the selected mode, following additional settings are required.
a) "NESTOR" mode
b) "NESTOR Probe" mode
3. Click "Submit" to activate the requested measurement mode.
For more details about the R&S NESTOR configuration and usage, refer to the user
documentation for R&S NESTOR.

6.3.4 ROMES Mode

In the "ROMES" mode, the ROMES software is hosted on the R&S TSMA6 and the
selection of a valid workspace file is required.
The ROMES mode is only displayed if the ROMES setup has been executed.
For the first time after installation, R&S ROMES has to be started from the Windows
desktop icon on the R&S TSMA6. After closing R&S ROMES, now it is possible to start
R&S ROMES via the R&S TSMA6 Web-GUI.
To use the R&S TSMA6 with R&S ROMES, the following steps must be performed.
User Manual 4900.8057.02 ─ 01
Chapter 6.2, "Measurement
Select a workspace and press "Submit".
The NESTOR application must be started on the host PC/tablet. The NESTOR
software installed on the host PC controls the measurement.
Configuring the R&S TSMA6
Measurement Modes
Setup", on page 27).
33