Refitting The Complete Cable Harness - ABB IRB 4600 - 40/2.55 Product Manual

4.3.2 Refitting the complete cable harness

Introduction
This procedure describes how to refit the complete cable harness.
How to remove the cable harness is described in
harness on page
The refitting procedure is presented in the order the work is recommended to be
performed.
Therefore the order is different in the two procedures removal and refitting of the
cable harness. Cross references will make it easy to find what is needed to know
as the work continues.
The section Refitting the complete cable harness consists of the following parts
presented in the order the work is recommended to be performed:
How to refit the SMB unit, brake release unit and motors can be found in:
3HAC033453-001 Revision: H
195.
• Refitting in the frame
• Refitting in the base
• Refitting in the lower arm and armhouse
lower arm and armhouse on page
• SMB unit Refitting the SMB unit on page 226
• Brake release unit Refitting the brake release unit on page 230
• Motors Refitting motors on page 286
© Copyright 2009-2013 ABB. All rights reserved.
4.3.2 Refitting the complete cable harness
Refitting the cable harness in the frame on page 210
Refitting the cable harness in the base on page 213
Refitting the cable harness in the
219.
4 Repair
Removing the complete cable
Continues on next page
207