Changing The Oil, Axis-1 Gearbox On Floor Mounted Robots - ABB IRB 4600 - 40/2.55 Product Manual

3 Maintenance

3.4.2 Changing the oil, axis-1 gearbox on floor mounted robots

3.4.2 Changing the oil, axis-1 gearbox on floor mounted robots
Floor mounted or suspended robot
Depending on whether the robot is floor mounted or suspended, the method of
changing the oil is different.
This section describes how to change the axis-1 gearbox oil in a floor mounted
robot.
Changing oil in a suspended robot
How to change the oil in a suspended robot see
on suspended robots on page
Location of oil plugs
The axis 1 gearbox is located between the frame and base of the robot.
The oil plugs of the different types, are shown in the figures.
Type C
Continues on next page
150
Note
The method of changing oil on the axis-1 gearbox is different on Type C compared
to Other design than Type C.
Both methods are described in this section.
Note
Only valid for type C.
Oil plugs for filling and draining are not depending on in which position the robot
is mounted:
• Draining = Oil plug on base.
• Filling = Oil plug on surface for motor flange.
© Copyright 2009-2013 ABB. All rights reserved.
Changing the oil, axis-1 gearbox
156.
3HAC033453-001 Revision: H