Table of Contents
Advertisement
4 Repair
4.7.1 Removing motors
4.7 Motors
4.7.1 Removing motors
Introduction
This procedure describes how to remove motors on all axes of the robot.
Location of axis-1 and axis-2 motors
The axis-1 and axis-2 motors are located as shown in the figure.
Motors:
(1) = Axis-1 motor
(2) = Axis-2 motor
xx0900000302
A
B
C
C
D
E
E
F
G
H
Continues on next page
278
Attachment screws M5x16, quality Steel 8-A2F (7 pcs)
Motor cover
Attachment screws, axis-1 motor (4 pcs) + washers. See
attachment screws on page 290
Attachment screws, axis-2 motor (4 pcs) + washers. See
attachment screws on page 290
Connection box
Axis-1 motor
Axis-2 motor
O-ring
Hole
Cable gland cover
© Copyright 2009-2013 ABB. All rights reserved.
Tightening torques and
Tightening torques and
3HAC033453-001 Revision: H
Advertisement
Table of Contents
