Changing The Oil, Axis-2 Gearbox - ABB IRB 4600 - 40/2.55 Product Manual

3 Maintenance

3.4.4 Changing the oil, axis-2 gearbox

3.4.4 Changing the oil, axis-2 gearbox
Location of oil plugs
The axis-2 gearbox is located in the lower arm rotational center, underneath the
motor attachment.
Oil plugs are shown in the figure.
xx0800000305
A
B
Required equipment
Equipment
Only valid for Other design than Type C:
Oil plug sealing washer, gearbox
Lubricating oil
Oil collecting vessel
Nipple (TEMA IF 3820 S06)
Standard toolkit
Continues on next page
162
Oil plug, filling (draining when suspended mounted)
Oil plug, draining (filling when suspended mounted) (Quick connect fitting)
© Copyright 2009-2013 ABB. All rights reserved.
Note
3HAC029646-001
Information about the oil is found in Technical
reference manual - Lubrication in gearboxes.
See Type and amount of oil in gearboxes on
page 148.
The capacity of the vessel must be sufficient
to take the complete amount of oil.
To be fitted on a hose, and then used for
draining connected to the quick connect fit-
ting.
See Location of oil plugs on page
Content is defined in section
on page 341.
3HAC033453-001 Revision: H
162.
Standard tools