Table of Contents
Advertisement
Parameter Download
Used to load the EMV parameters into the PIN-Pad. Perform this after loading the Datacap device
(see "Parameter Download" on page 206).
1. Turn the control lock to the Z position.
2. Press 5 and CASH to select the Datatran Function menu.
3. Press 3 and CASH to initiate the Parameter Download.
4. The message: "ARE YOU SURE" displays. Press the YES/NO key to select YES and then
press CASH.
5. At the register, the message: "WAITING FOR EFT" displays. At the PIN-Pad, the message
"LOADING" displays.
6. When complete the message: "LOAD SUCCESS" will display and print. The PIN-Pad will
re-initialize.
7. At the register, press CLEAR to complete the procedure.
EMV EBT Voucher
When the EBT/Tran equipment is not able to connect to the processing center and the customer is not
able to process EBT via the integrated system they would use this operation to manually enter the
EBT transaction.
The customer would need to call the processing center to get an approval for the transaction.
1. Turn the control lock to the Z position.
2. Press 5 and CASH to select the Datatran Function menu.
3. Press 4 and CASH to initiate the EBT Voucher.
4. At the prompt, Enter Amount on ECR and press CASH. (i.e. 500 CASH)
5. Enter the Auth. Code; enter the code on the ECR and press CASH.
6. Enter Voucher Number; enter the voucher number at the ECR and press CASH.
7. The PIN-Pad will display $5.00 OK? Press the green button on the vx805 to confirm.
8. At the prompt: Tap or swipe the Card, insert the chip card into the vx805.
Note: When entering the Auth. Code, you must use the three-digit alpha character code entry method.
206 • Integrated Payment Appendix
Sam4s ER-260EJ/256EJ OP Manual v1.20
Advertisement
Table of Contents
