Table of Contents
Advertisement
10. When complete, the message Completed displays on the PC. Click OK and the
Program Area Update
1. Connect the Serial Cable from ECR to PC.
2. At the register, move to the SERVICE MODE.
3. Turn the power switch to the OFF position.
4. Press the upper right key and the lower right key. A rapid beep-beep-beep sound will
5. Press the ↑ key and the ↓ key to select menu and press the CASH key to confirm.
6. At the PC, execute the program "Download.exe". The Download dialog box
7. Select the appropriate com port connection at your PC at the PORT# option buttons.
8. Click
9. Select Program code + Font in the Select One option buttons.
10. Press OK Button. The download takes about 3 minutes. At the PC, the scroll bar
11. When complete, the message Completed displays at the PC. Click OK and the
12. Disconnect the PC cable.
13. Perform a memory all clear on the ECR. The ECR is now ready to program or to
102 • Service Mode Programming
progress of the download. At the ECR, the display will flash slowly while the update
is taking place.
Download program will close. At the ECR, the display will change to a blue color
indicating the update is complete. Turn the power switch to the OFF.
be heard. Release the upper right key and the lower right key.
Select the 1.SERIAL1 menu.
displays.
find the folder where the update files are located and select binary file.
will track the progress of the download. At the ECR, the display will flash (Current
program is being erased), after a few seconds, the display will continue to flash, but
at a slower rate. This continues for about 3 minutes while the new program is being
loaded.
Download program will close. At the ECR, when the load is complete, a rapid beep-
beep-beep will be heard, and the display will flash rapidly. Turn the power switch to
OFF, the program update is complete.
load a previously saved end-user program.
Sam4s ER-260EJ/256EJ OP Manual v1.20
Advertisement
Table of Contents
