Table of Contents
Advertisement
EMV Related Datatran Operations
All EMV related management functions take place with the control lock in the Z position. In this
way, only those with the correct key will have access to these operations.
The following Z mode menu selections are used in EMV related operations:
In the Pre-EMV environment Datacap stored some information at the DataTran device that allowed
the registers to run some reports, such as the local transaction report.
In the EMV environment Datacap is no longer storing information at the DataTran device so there are
no batch reports available at the ECR. The "Delete SD EMV File" operation should be performed
daily.
On the ER-260EJ/ER-265EJ we are storing some information on the approvals at the register
(EMVBACK.txt file). This is required to be able to perform "By Record" transactions. No credit card
or customer information is stored at the ECR.
Sample EMVBACK.txt file:
Currently, if a Local Transaction Report is run we print the information from the approvals in the
EMVBACK.txt file. However, this data should only be used for troubleshooting and should not be
relied upon as accurate reporting data.
For example, if you perform a sale for $1.00 and then perform a Void by Record Number of the same
transaction, you will have two transactions. The register is only printing the information from the
approvals.
Accessing Z Mode Functions
1. Move the key to the Z keylock position to display the Z Mode menu.
2. You can now use the CHARGE1 and the CHARGE2 keys to scroll up and down through
the Z Mode menu. Or, if you already know the menu number of the X Mode function you
with to perform, you can enter the digit (1-6) directly.
The following Z Mode functions are available:
202 • Integrated Payment Appendix
Datatran Function
Datatran Transaction
1.Z REPORTS
2.RE SET E.J
3.RE SET NOT FOUND PLU
4.CO NNECT SE RVER
5.DA TATRAN F UNCTION
6.DA TATRAN T RANSACTION
Sam4s ER-260EJ/256EJ OP Manual v1.20
Advertisement
Table of Contents
