Table of Contents
Advertisement
Option
PROMPT WHEN E.J.
2
BUFFER IS FULL
STOP OPERATIONS WHEN
3
E.J. BUFFER IS FULL
SEND ONLY NEGATIVE
4
ENTRIES TO E.J.
SEND RESET REPORT TO
5
E.J.
E.J PRINTING
6
E.J PORT (0-3)
7
PRINT SMALL FONT EJ
8
REPORT
TRAIN MODE Options
#
Option
OPEN DRAWER IN TRAIN
1
MODE
PRINT TRAIN MODE
2
TITLE
SEND TO KP IN TRAIN
3
MODE
TRAIN P/W
4
PRT TRAIN CLERK
5
START/END MESSAGE
Sam4s ER-260EJ/256EJ OP Manual v1.20
Entry
Description
Y or N
If the electronic journal is enabled above, select Y if you
wish to display a message to notify the operator when the
journal memory is full.
If the electronic journal is enabled above, select Y if you
Y or N
wish to stop operations when the journal memory is full.
If the electronic journal is enabled above, select Y if you
Y or N
wish to capture only transactions with negative entries.
Y or N
If the electronic journal is enabled above, select Y if you
wish to capture reset reports.
NEW
NEW: Prints electronic journal from lowest consecutive
number to highest.
OLD
OLD: Prints electronic journal from highest consecutive
number to lowest.
0-3
Choose a port for a remote printer to print electronic
journal reports instead of the register printer.
Y or N
Select Y to print small font on EJ report.
Entry
Description
Y or N
Select N if you do not want the cash drawer to open
during training mode operations.
Y or N
When in training mode, the message "TRAIN MODE"
normally prints on each receipt. Select N if you wish to
delete this message.
You can choose whether to print or not print registrations
Y or N
in training mode on kitchen requisitions.
If you wish to use training mode, you must program a
6 DIGIT
password that you will use to enter training mode. The
password may be up to 6 digits.
Y or N
Select N if you do not wish to print a message of train
clerk start or end.
Program Mode Programming • 153
Advertisement
Table of Contents
