Shutdown Alarm - Smartgen HGM410E User Manual

Low
19
Pressure 2
Low Fuel Level
20
2

5.2 SHUTDOWN ALARM

When controller detects shutdown alarm, it will send signal to open breaker and stop the
genset. The alarm information will be displayed on LCD.
No Items
Emergency
1
Shutdown
High
2
Temperature
Low
3
Pressure
4 Over Speed
5 Under Speed
Loss Of Speed
6
Signal
Gen Over
7
Voltage
Gen Under
8
Voltage
HGM400E Series Genset Controller
HGM400E Series Automatic Control Module
When the controller detects that flexible sensor oil pressure
(sensor type: oil pressure sensor) has fallen below the
Oil
pre-set value while shutdown is prohibited, it will initiate a
warning alarm and the corresponding alarm information will
be displayed on LCD.
When the controller detects that flexible sensor fuel level
(sensor type: level sensor) has fallen below the pre-set value
while shutdown is prohibited, it will initiate a warning alarm
and the corresponding alarm information will be displayed on
LCD.
When the controller detects that the emergency shutdown
signal, it will initiate a shutdown alarm and the corresponding
alarm information will be displayed on LCD.
When controller detects that the water/cylinder temperature
has exceeded the pre-set value, it will initiate a shutdown
alarm and the corresponding alarm information will be
displayed on LCD.
When the controller detects that the oil pressure has fallen
Oil below the pre-set value, it will initiate a shutdown alarm and
the corresponding alarm information will be displayed on
LCD.
When the controller detects that the generator speed has
exceeded the pre-set value, it will initiate a shutdown alarm
and the corresponding alarm information will be displayed on
LCD.
When the controller detects that the generator speed has
fallen below the pre-set value, it will initiate a shutdown alarm
and the corresponding alarm information will be displayed on
LCD.
When the controller detects that the engine speed is 0 and
the delay is NOT 0, it will initiate a shutdown alarm and the
corresponding alarm information will be displayed on LCD.
When the controller detects that the genset voltage has
exceeded the pre-set value, it will initiate a shutdown alarm
and the corresponding alarm information will be displayed on
LCD.
When the controller detects that the genset voltage has
fallen below the pre-set value, it will initiate a shutdown alarm
and the corresponding alarm information will be displayed on
ISSUE 2013-08-28
Description
Version 1.1 Page 15 of 41