Commissioning - Smartgen HGM410E User Manual

10 COMMISSIONING

Please make the under procedures checking before commissioning,
1. Ensure all the connections are correct and wires diameter is suitable.
2. Ensure that the controller DC power has fuse, controller's positive and negative
connected to start battery are correct.
3. Take proper action to prevent engine to crank success (e. g. Remove the connection
wire of fuel valve). If checking is OK, make the start battery power on; choose
manual mode and controller will executive routine.
4. Set controller under manual mode, press "start" button, genset will start. After the
cranking times as setting, controller will send signal of Start Failure; then press "stop"
to reset controller.
5. Recover the action to prevent engine to crank success (e. g. Connect wire of fuel
valve), press start button again, genset will start. If everything goes well, genset will
normal running after idle running (if idle run be set). During this time, please watch
for engine's running situations and AC generator's voltage and frequency. If
abnormal, stop genset and check all wires connection according to this manual.
6. Select the AUTO mode from controller's panel, connect mains signal. After the
mains normal delay, controller will transfer ATS (if fitted) into mains load. After
cooling time, controller will stop genset and make it into "at rest" mode until there is
mains abnormal situation.
7. When mains is abnormal again, genset will be started automatically and enter into
normal running, then controller send signal to making generator switch on, and
control the ATS transfer into generator load. If not like this, please check ATS' wires
connection according to this manual.
8. If there is any other question, please contact Smartgen's service.
HGM400E Series Genset Controller
HGM400E Series Automatic Control Module
ISSUE 2013-08-28 Version 1.1 Page 36 of 41