Connections - Smartgen HGM410E User Manual

6

CONNECTIONS

Compared with HGM420E, HGM410E has no Mains AC Voltage input terminals. The
rear panel of HGM410E and HGM420E is as below.
Description of terminal connections:
Pin Function
1 B-
2 B+
3 Aux. Output 1
4 Crank
5 Aux. Output 2
6 Aux. Output 3
7 Aux. Input 1
8 Aux. Input 2
9 Aux. Input 3
HGM400E Series Genset Controller
HGM400E Series Automatic Control Module
Cable
Size
2
1.5mm
2
1.5mm
2
1.0mm
2
1.0mm
2
1.0mm
2
1.0mm
2
1.0mm
2
1.0mm
2
1.0mm
ISSUE 2013-08-28
Description
DC power supply.
negative of starter battery.
DC power supply.
positive of starter battery. If wire length is
over 30m, better to double wires in
parallel. Max. 20A fuse is recommended.
B+ is supplied by 2 point, rated 5A.
B+ is supplied by 2 point, rated 5A.
Connect to starter coil.
B+ is supplied by 2 point, rated 5A.
B+ is supplied by 2 point, rated 5A.
Ground connected
active (B-)
Ground connected is
active (B-)
Ground connected
active (B-); Can be used
Version 1.1
Connected with
Connected with
is
See Table 3
is
Page 18 of 41