Installation; Fixing Clips; Overall Dimension And Panel Cutout - Smartgen HGM410E User Manual

12 INSTALLATION

12.1 FIXING CLIPS

Controller is panel built-in design; it is fixed by clips when installed..
1) Withdraw the fixing clip screw (turn anticlockwise) until it reaches proper position.
2) Pull the fixing clip backwards (towards the back of the module) ensuring two clips
are inside their allotted slots.
3) Turn the fixing clip screws clockwise until they are fixed on the panel.
Note: Care should be taken not to over tighten the screws of fixing clips.

12.2 OVERALL DIMENSION AND PANEL CUTOUT

1) Battery Voltage Input
HGM400E series controller can suit for widely range of battery voltage DC(8~35)V.
HGM400E Series Genset Controller
HGM400E Series Automatic Control Module
ISSUE 2013-08-28 Version 1.1 Page 39 of 41