(Table 3) - Smartgen HGM410E User Manual

7.3 PROGRAMMABLE
CONNECT GND (B-) (TABLE 3)
No Items
0 Not Used
High Temperature
1
Input
Low Oil
2
Warning Input
3 Auxiliary Warning
Emergency
4
Shutdown
High Temperature
5
Stop Input
6 Generator Closed
7 Mains Closed
Inhibit
8
Temperature Stop
Inhibit Low
9
Pressure Stop
10 Remote Start
11 Fuel Level Warn
12 Coolant Level Warn
Fuel
13
Shutdown
Coolant
14
Shutdown
15 Auto Start Inhibit
HGM400E Series Genset Controller
HGM400E Series Automatic Control Module
INPUT
If these signals are active after safety on delay,
shutdown alarm will be immediately initiated.
Pressure
Only warning and not stops if this input is active.
Shutdown alarm will be immediately initiated if this
input is active.
When the gen-set is running normally and this signal is
activated, if there is a high temperature situation, the
controller will first cool down the generator and then
stop it; if the signal is deactivated and a high
temperature situation occurs, the controller will shut
down the gen-set without cooling down.
HGM410E without
High When it is active, prohibit stopping when high
temperature occurs. Note 1
Oil When it is active, prohibit stopping when low oil
pressure occurs. Note 2
HGM420E without
Level
Level
In Auto mode, if this input is active, whether mains is
normal or not (HGM420E) or a remote start signal
occurs (HGM410E), the controller will not give a start
command to the generator. If generator is normal
running, stop command won't be executed. When this
input is deactivated, genset will automatically start or
stop according to the mains status (normal or
abnormal).
ISSUE 2013-08-28
1-4 TABLE
Description
Version 1.1
(ACTIVE WHEN
Page 30 of 41