RIBBON REWIND ASSEMBLY
RIBBON REWIND MOTOR
Some of the procedures in this section require that
the electrical power to the machine remain ON.
WARNING
USE EXTREME CAUTION WHILE SERVICING
A MACHINE WHILE POWER IS APPLIED.
UNEXPECTED
MACHINE
CAUSE SERIOUS INJURY.
WARNING
DO
NOT
ATTEMPT
MACHINE DURING NORMAL OPERATION.
KEEP
HANDS
AND
MOVING PARTS.
WARNING
WHILE
TESTING
COMPONENTS WITH POWER APPLIED TO
THE
MACHINE,
TROUBLESHOOTING
AVOID ELECTRICAL SHOCK.
SX™
Service and Maintenance Manual
PRINTHEAD CRADLE ASSEMBLY
STARTUP
CAN
TO
SERVICE
THE
ARMS
CLEAR
OF
ELECTRICAL
USE
PROPER
TECHNIQUES
TO
SECTION 3 – COMPONENT REPAIR
TESTING
1. Remove the outside cradle cover.
Outside Cradle
Figure 3-190. Removing the Outside Cradle Cover
2. Press the "Feed" button on the printer control
panel, and watch the ribbon rewind motor. If
the motor spins and the rewind hub does not,
the ribbon motor is working properly and further
troubleshooting of the ribbon rewind assembly
is required.
READY
Feed Button
PAUSE
REV
ESC
ESC
MENU
Figure 3-191. Printer Control Panel
3-76
Screws
STOP
ERROR
FEED
CANCEL
FWD
ENT
TEST
960714-02B © 2007 I2407