PRINTHEAD POSITION DRIVE BELT
(con't)
REPLACEMENT
1. Remove the outside cradle cover.
Outside Cradle
Screws
Figure 3-228. Removing the Outside Cradle Cover
2. Unplug the motor cable.
3. Remove the four bolts that mount the printhead
position motor to the outside cradle plate.
Slide the motor to the front of the machine to
release the belt from the motor pulley. Once
the belt is free, slide the motor up to remove
from the machine.
SX™
Service and Maintenance Manual
PRINTHEAD CRADLE ASSEMBLY
4. Remove the outside cradle plate from the
3-93
SECTION 3 – COMPONENT REPAIR
Figure 3-229. Printhead Position Motor Screws
machine. This is done by removing three
screws from the side of the plate and two
screws from the front edge. Once the plate is
free, gently side it off the transfer shaft and
remove from the machine.
Figure 3-230. Outside Cradle Plate Screws
960714-02B © 2007 I2407