Sharp SX 1075 Service Maintenance Manual page 119

PRINTHEAD PRESSURE CAMS (con't)
18. Return the gas spring into position.
shoulder bolt through clevis end on spring, and
slide the four nylon washers over the shoulder
bolt. Tighten into plate.
4 Nylon Washers
Figure 3-249. Gas Spring and Nylon Washers
19. Reinstall the cradle latch lever.
replace the nylon washer between the bushing
and the latch. When tightening the latch into
position, make sure the shaft is completely
moved over to the right. Hold the opposite end
of the shaft tight to the left plate.
Cradle Latch Lever
Hold This End
Figure 3-250. Reinstalling the Cradle Latch
SX™
Service and Maintenance Manual
PRINTHEAD CRADLE ASSEMBLY
Insert
Gas Spring
Be sure to
SECTION 3 – COMPONENT REPAIR
20. Check the position of the sensor flag manually.
Turn the transfer shaft pulley back and forth to
ensure the flag will not hit the front or rear plate
support. If severe interference is indicated,
adjust the sensor flag by turning the pulley
counterclockwise to position the printhead at its
highest position (Fig. 3-251). The sensor flag
should be parallel to the pinch roller brackets in
this position (Fig. 3-252).
Move Pulley in
This Direction
Figure 3-251. Transfer Shaft Pulley
Figure 3-252. Sensor Flag Position
21. Replace the outside cradle cover.
3-100
Flag and Bracket
Parallel
960714-02B © 2007 I2407