Sharp SX 1075 Service Maintenance Manual page 147

STRIPPER PLATE ASSEMBLY (con't)
14. Lift the heater block into position, and install
the eight mounting screws with lock and flat
washers through the holes in the horizontal
mounting plate (Figure 3-323). The Teflon tape
and heater band should be aligned with the
opening in the stripper plate at proper
orientation.
Figure 3-323. Heater Block Mounting Screws
Note: Viewed from Rear; Cradle Removed for Clarity
15. Reinstall the front finger plate, visually aligning
the "fingers" with the grooves in the film feed
roller. Ensure the fingers do not rub on the
roller, but are as close as possible to ensure
the bags feed through the machine correctly.
Be cautious of the photoelectric eye wires,
being sure to not excessively pull on them.
16. Place the film feed roller belt over the film feed
drive pulley on the transfer shaft (if removed)
and ensure the nylon washer is still in position
on the shaft. Slide the transfer shaft into the
machine until the shaft is fully seated in the
inside bearing on the left bearing plate. The
outer transfer shaft pulley should be aligned
with the film feed drive motor pulley when the
transfer shaft is in its correct position. Once in
position, insert the film feed drive pulley into
the belt, and slide pulleys in unison until they
are in position (Figures 3-324 and 3-325).
SX™
Service and Maintenance Manual
SECTION 3 – COMPONENT REPAIR
SEALER ASSEMBLY
Figure 3-324. Reinserting the Transfer Shaft
Note: Viewed from Rear; Cradle Removed for Clarity
Roller Drive
Note: Viewed from Rear; Cradle Removed for Clarity
17. Align the flat areas of the shaft with the set
screws on the pulleys loosened in step 4
above. Slide the film feed roller drive pulley
tight to the nylon washer, and tighten set
screws to secure in place. Align the film feed
roller driven pulley with the drive pulley, and
tighten into position. If equipped with a printer,
also tighten the set screws on the platen roller
drive pulley.
3-127
Left Bearing Plate
Nylon Washer
Roller Driven
Film Feed
Pulley
Figure 3-325. Pulleys
Film Feed
Pulley
Platen Roller
Drive Pulley
(Optional)
960714-02B © 2007 I2407