Sharp SX 1075 Service Maintenance Manual page 146

STRIPPER PLATE ASSEMBLY (con't)
10. With the stripper plate assembly completely
free of the machine, remove the two shoulder
bolts that hold the stripper plate to the spring
blocks. Each bolt has a nylon washer between
the spring and the block.
these washers, as they are needed during
reinstallation (Figure 3-319).
Figure 3-319. Stripper Plate Mounting
11. Take one spring block, and remove one of the
set screws. Remove the spring and gripper
button from the block, and replace with the new
components. Reinstall the set screw with
®
Loctite Blue, and turn until the screw is
protruding 1/8".
button springs the proper preload. Repeat this
procedure for the other spring and gripper
button, and for the other block (Figure 3-320).
Spring Block
Spring
Set Screw
Figure 3-320. Gripper Button Components
SX™
Service and Maintenance Manual
SEALER ASSEMBLY
Do not misplace
Shoulder
Bolts
This will give the gripper
Gripper Button
SECTION 3 – COMPONENT REPAIR
12. Reinstall the shoulder bolts through the spring
blocks and into the stripper plate according to
Figure 3-321.
nylon washers removed in step 10.
Stripper
Plate
Spring
Figure 3-321. Mounting the Stripper Plate
13. Reinstall the stripper plate assembly into the
machine. Place on top of the jaw guide rails
with the spring blocks turned 90° from their
mounting position, and slide through the plate.
Once the stripper plate is completely into the
machine, turn the spring blocks to their
mounting positions, and insert the eight
mounting screws through the horizontal plate
(Figure 3-322).
Figure 3-322. Reinstalling the Stripper Plate Assembly
Note: Stripper Plate Assembly and Selected Components
Isolated for Clarity
3-126
Remember to install the two
Nylon
Washer
Shoulder
Bolt
960714-02B © 2007 I2407