Sharp SX 1075 Service Maintenance Manual page 118

PRINTHEAD PRESSURE CAMS (con't)
12. Reinsert the cam shaft into the machine
through the printhead lift bracket and into the
left inner plate. Slide the nylon washer into
position next to the bearing, and continue to
slide the cam shaft into the transfer shaft. Be
sure the cam shaft is completely pressed into
the transfer shaft.
Nylon Washer
Figure 3-245. Reinstalling the Cam Shaft
13. Tighten the set screw in the transfer shaft onto
the flat area of the cam shaft, making sure the
cam shaft is fully inserted.
14. Reposition the sensor flag according to the
marks made in step 3. It is crucial the sensor
flag is positioned in the correct spot for proper
machine operation. However, adjustments can
be made when reassembly is completed.
Figure 3-246. Transfer Shaft and Sensor Flag
SX™
Service and Maintenance Manual
PRINTHEAD CRADLE ASSEMBLY
Printhead Lift
Bracket
Sensor Flag
Transfer Shaft
SECTION 3 – COMPONENT REPAIR
15. Reinstall the two left screws on the front cross
member bar.
Figure 3-247. Front Cross member Screws
16. Mount the right inner plate with the five screws
removed in step 7, and reinstall the E-Clip on
the printhead pivot shaft removed in step 6.
17. Rotate the right side cradle plate up into
position. Reinstall the roller removed in step 5,
and move plate into position to align screw
holes. Reinstall eight screws.
Roller
Figure 3-248. Screw Identification for Right Side Plate
3-99 960714-02B © 2007 I2407