Sharp SX 1075 Service Maintenance Manual page 105

SECONDARY RIBBON DRIVE BELT
(con't)
Nylon Washers
Figure 3-211. Interior Transfer Shaft Components
Note: Cradle Cover Removed for Clarity
6. Remove the E-Clip from the ribbon take-up
shaft. This clip is located between the outside
cradle plate and the main cradle plate, outside
of the gray housing located in the lower-rear
section of the area exposed by the outside
cradle cover.
Ribbon Rewind
Shaft E-Clip
Figure 3-212. Ribbon Rewind Shaft E-Clip
SX™
Service and Maintenance Manual
PRINTHEAD CRADLE ASSEMBLY
DC Roller Clutch Pulley
SECTION 3 – COMPONENT REPAIR
7. Loosen the two set screws on the adjustable
slip clutch.
Slip Clutch
Figure 3-213. Adjustable Slip Clutch
8. Remove the ribbon take-up hub from the
machine by pulling it through the opening in the
latch-side plate. When removing the hub, the
slip clutch, a nylon washer, a nylon spacer, a
flange bearing on the gray housing, and the
belt will all be free from the machine. Do not
misplace these parts, as they are needed for
reinstalling the ribbon hub.
Nylon
Washer
Rewind
Hub
Figure 3-214. Rewind Hub Shaft Components
Note: Plate Cut Away for Clarity
3-85
Slip
Clutch
Flanged
Nylon
Spacer Bearing
960714-02B © 2007 I2407