Sharp SX (con't)
5. Release the cradle latch and open the cradle.
Remove the pulley cover to expose the drive
roller belt.
6. Check the film feed drive roller belt for tension
(Figure
2-9).
This
approximately 1/16" using one finger to push
on the center of the belt span. If adjustment is
needed, loosen the idler screw and slide to
increase tension. Retighten screw and check
tension.
SX™
Service and Maintenance Manual
Film Feed Roller
Drive Belt
Figure 2-8 Pulley Guard Screws
Note: Cradle Removed for Clarity
SECTION 2 – MAINTENANCE AND ADJUSTMENTS
MACHINE ADJUSTMENTS
belt
should
deflect
7.
Reinstall frame guard and pulley guard that
were removed earlier. Close cradle and lock
into position.
2-7
960714-02B © 2007 I2407