24 Vdc Fan Assembly - Sharp SX 1075 Service Maintenance Manual

24 VDC FAN ASSEMBLY

The 24 VDC Fan Assembly is only present in Sharp
TM
SX Baggers that are equipped with a printer.
TESTING
There are no testing procedures for the 24 VDC
Fan Assembly. If the fan is not receiving power,
the printer will not turn on, as they both use the
same power source.
ADJUSTMENT
There are no adjustments necessary on the 24
VDC Fan Assembly
REPLACEMENT
WARNING
Always remove electrical power from the
SX prior to performing any maintenance
on the machine.
1. Remove six screws holding Frame Guard, set
screws and Frame Guard aside (Figure 3-125).
2. Snap off Air Filter Holder (Figure 3-126).
3. Remove Filter (clean if necessary).
4. Remove four screws holding 24 VDC Fan to
Rear Face Plate. When removing last screw,
hold fan so it doesn't fall (Figure 3-127).
5. Unplug and remove fan.
6. Using the screws from the old fan, screw the
replacement fan to the Rear Face Plate.
7. Snap Air Filter Holder and Air Filter onto Fan
Guard.
8. Reconnect power cord to Power Supply Board.
9. Replace Frame Cover.
SX™
Service and Maintenance Manual
ELECTRICAL COMPONENTS (1099 & 1108)
SECTION 3 – COMPONENT REPAIR
Figure 3-125. Frame Cover Screws
Figure 3-126. Fan Cover
Figure 3-127. Remove Fan Guard
3-48 960714-02B © 2007 I2407