PRINTER POWER SUPPLY BOARD
TESTING
There are no testing procedures for the Printer
Power Supply Board.
ADJUSTMENT
There are no adjustments necessary on the Printer
Power Supply Board.
REPLACEMENT
WARNING
Always remove electrical power from the
SX prior to performing any maintenance
on the machine.
1. Remove the six screws holding the Frame
Cover, set screws and Frame Cover aside
(Figure 3-119).
2. Remove any bags on a roll from the machine.
3. Remove the seven screws from the Mandrel
Support Plate (Figure 3-120 & 3-121).
SX™
Service and Maintenance Manual
ELECTRICAL COMPONENTS (1099 & 1108)
SECTION 3 – COMPONENT REPAIR
Figure 3-119. Frame Cover Screws
Figure 3-120. Mandrel Support Screws
Figure 3-121. Mandrel Support Plate Bottom
3-46
Mandrel
Support
screws
Plate
screws
Screws
960714-02B © 2007 I2407