Stripper Plate Sensors - Sharp SX 1075 Service Maintenance Manual

STRIPPER PLATE SENSORS

The stripper plate sensors are part of the
Obstruction Sensing Jaw.
located inside the machine on each end of the
stripper plate, and are activated by flags on the
plate. If they are not working, the machine will go
into a jaw fault and will not cycle.
Some of the procedures in this section require that
the electrical power to the machine remain ON.
WARNING
USE EXTREME CAUTION WHILE SERVICING
A MACHINE WHILE POWER IS APPLIED.
UNEXPECTED MACHINE
CAUSE SERIOUS INJURY OR DEATH.
WARNING
DO NOT ATTEMPT
MACHINE DURING NORMAL OPERATION.
KEEP HANDS AND
MOVING PARTS.
WARNING
WHILE TESTING
COMPONENTS WITH POWER APPLIED TO
THE MACHINE,
TROUBLESHOOTING
AVOID ELECTRICAL SHOCK.
TESTING
1. Remove the outside frame guard (Figure 3-
342).
SX™
Service and Maintenance Manual
SEALER ASSEMBLY
The two sensors are
STARTUP CAN
TO SERVICE THE
ARMS CLEAR OF
ELECTRICAL
USE PROPER
TECHNIQUES TO
SECTION 3 – COMPONENT REPAIR
Outside
Frame
Guard
Figure 3-342. Guard Identification
2. Locate the 6-positon junction box. Ensure the
plugs are fully inserted into the ports. The left
stripper plate sensor will be in the receptacle
numbered '5' and the right sensor will be in
receptacle '6' (Figure 3-343).
Left Sensor Plug
Right Sensor Plug
(Receptacle 6)
Figure 3-343.Stripper Plate Sensor Plugs
3-135
(Receptacle 5)
960714-02B © 2007 I2407