Sfp28 Module Connectors - Xilinx ZCU111 User Manual

SFP28 Module Connectors

[Figure 2-1, callouts 14, 15]
The ZCU111 board hosts four SFP28 connectors J27, J32, J37, and J42. The connectors are
housed within a single quad SFP28 cage assembly. The ganged SFP28 cage supports up to
four SFP/SFP+/SFP28 modules.
typical of the four implementations.
The SFPx_TX_DISABLE default 2-pin jumper is On, which means the SFPx_TX_DISABLE net is
Note:
pulled Low, enabling the TX output of the SFP module.
X-Ref Target - Figure 3-23
ZCU111 Board User Guide
UG1271 (v1.1) August 6, 2018
Figure 3-23 shows the SFP28 module connector circuitry
Figure 3-23: SFP28 Module Connectivity
www.xilinx.com
Chapter 3: Board Component Descriptions
Send Feedback
X20491-062118
60