Xilinx ZCU111 User Manual page 85

System Reset Pushbuttons
[Figure 2-1, callout 54]
Figure 3-36 shows the reset circuitry for the PS.
X-Ref Target - Figure 3-36
Figure 3-36: PS SRST_B and POR_B Pushbutton Switches SW3 and SW4
PS_POR_B Reset
Depressing and then releasing pushbutton SW4 causes net PS_POR_B to strobe Low. This
reset is used to hold the PS in reset until all PS power supplies are at the required voltage
levels. It must be held Low through PS power-up. PS_POR_B should be generated by the
power supply power-good signal. When the voltage at IN1 is below its threshold or EN1
(P.B. switch SW4 is pressed) goes Low, OUT1 (PS_POR_B) goes Low.
ZCU111 Board User Guide
UG1271 (v1.1) August 6, 2018
Chapter 3: Board Component Descriptions
www.xilinx.com
X20574-062118
85
Send Feedback