Mitel 470 System Manual page 56

Expansion Stages and System Capacity
1)
DECT VoIP FoIP
3 3
1) Licence(s) required (see also "Licences", page 70).
2) Of relevance only to certain countries such as Brazil
Tab. 22 Max. number of channels per DSP chip on SM-DSP1
1)
DECT Audio
10
8
6 18
46
1) Licence(s) required (see also "Licences", page 70).
Notes
– To configure VoIP channels on the DSP chip of a DSP module, make sure the
parameter in the
the IP media modules the configured
VoIP mode
licence. The G.711 VoIP channels of the configurable DSP chip on processor card CPU1
can be combined with G.711 VoIP channels of DSP modules.
– If audio channels are configured and licensed, the two basic audio channels that can be
used without a licence are redundant (see Tab. 16).
– Audio channels and FoIP channels can only be configured on one DSP chip per node.
– The system has to be restarted for the configuration changes of the DSP to take effect.
– After a first start all the DSP chips are configured on DECT.
1) Although no longer available, the module is still supported.
56
1) 1)
Audio GSM FXO
46
64
1)
GSM Remarks
10
10
Media resources (
is set to G.711, two G.711 VoIP channels per system can be used without a
2)
CAS Remarks
150
1)
or SM-DSP2
=ym) view is not set to
VoIP mode applies to all the DSP chips of a node. If
1)
VoIP mode
No VoIP. With the exception of
Mitel 470 as of R4.1
syd-0585/1.2 – R4.1 – 08.2016