Digital System Phones; General Information - Mitel 470 System Manual

Installation
4. 8. 6

Digital system phones

4. 8. 6. 1

General information

Accesses
The connections on the underside of the system phones are identified by the symbols.
The meaning of the symbols is described in the corresponding operating instructions.
DSI terminal interface
Tab. 82 DSI interface on the phone
RJ45 socket
Note:
The total length of the cables from the communication server to the system phone must not be
less than 10 m.
Terminal selection
Two system phones can be connected to a DSI interface (DSI-AD2 only). The system
can only differentiate the two system phones by the position of the address switch on
the phone. The following settings are possible (TSD = Terminal Selection Digit):
• TSD1
• TSD2
Note:
In the following cases
and the port number. In this state the system phone is not ready for operation:
– A terminal has been created at the connected port, but the address selection switch is incor-
rectly set.
– No terminal has yet been created at the connected port.
User allocation
In the configuration each terminal is assigned to a user or a free seating pool. If a ter-
minal has been created at the connected port and the address selection switch is cor-
rectly selected but no user or free seating pool is allocated to the terminal, the system
162
Pin Signal
1 —
2 —
3 b
4 a
5 —
6 —
Not Configured is displayed along with the node number, the slot number
Mitel 470 as of R4.1
syd-0585/1.2 – R4.1 – 08.2016