Operating State And Error Displays; System Operating State; System Error Displays - Mitel 470 System Manual

→ The system status of the communication server in the SRM agent remains on
Critical, and the destinations on red, because there is still an event message with
this severity.
4. The event message
→ The communication server's system status in the SRM agent changes to Normal,
and the destinations turn red.
After a first-start of the communication server, the
located event table 7. The notification service to the SRM destination can be switched
on or off.
On the SRM server the status modification per communication server must be allowed
and configurations are also required in WebAdmin. You can find a configuration guide
in WebAdmin help under the
Testing the signal destination configuration
To test the configuration, a test event message can be separately initiated for each
destination in the WebAdmin configuration
event message is signalled without any delay, directly at the selected signal destina-
tion.
If the communication server is connected via a modem or terminal adapter, the test
event messages will be signalled only once the connection is cleared down.
6. 6. 2

Operating state and error displays

6. 6. 2. 1

System operating state

During the start-up phase, various self-tests are performed and the individual phases
are indicated with the status LED on the front panel (see "Status LED", page 217).
When operation is OK, the status LED flashes green, regularly, and once per second in
the display on the front panel. The system is in normal operation mode. All additional
information and operating modes are indicated using the colour display on the front
panel (see "Colour display", page 220).
6. 6. 2. 2

System error displays

Whenever the system detects an error, it displays the corresponding error code in the
colour display on the front panel (providing the communication server is still powered
and the display is working). During system startup, if the colour display is not yet fully
Mitel 470 as of R4.1
syd-0585/1.2 – R4.1 – 08.2016
Fan failure reaches the SRM server.
Message destinations
Operation and Maintenance
SRM destination
=h1 view.
(Message destinations
is automatically al-
=h1 view). The
245