Mitel 470 System Manual page 157

Fig. 70 Connection possibilities for Ethernet interfaces
Note
Circuit type as per EN/IEC 60950: SELV
Socket
Tab. 75 Connection of Ethernet interfaces
RJ45 socket
Settings
The IP address can either be taken from a DHCP server in the IP network or config-
ured statically. If a DNS server is used, the communication server can also be ad-
dressed via its host name.
Tab. 76 Default values, IP address
Parameter
IP address
Subnet mask
Gateway
DHCP
Host name
1) This entry is hidden and does not appear in the parameter's input field
First-start response
The IP addressing after a first start depends on whether a static IP addressing is al-
ready stored on the EIM card from a previous configuration. A static IP addressing (IP
address, subnet mask, gateway) entered manually is stored on the EIM card and re-
Mitel 470 as of R4.1
syd-0585/1.2 – R4.1 – 08.2016
Pin Signal
1 TX D1+
2 TX D1–
3 RX D2+
4 BI D3+
5 BI D3–
6 RX D2–
7 BI D4+
8 BI D4–
Parameter value
192.168.104.13
255.255.255.0
0.0.0.0
yes
<Model name>-<MAC-Address>
Example: Mitel430-00085d803100
Installation
1)
157