Fitting Ip Media Modules - Mitel 470 System Manual

4. 5. 6

Fitting IP Media modules

IP Media modules are fitted either to the Call Manager card or to PRI trunk cards. IP
Media modules are not stackable.
To fit an IP Media module to a Call Manager card, proceed as follows:
Warning
Be sure to observe the "Safety regulations", page 94.
1. Shut down the call manager via the control panel (see "On/Off key", page 217).
2. Unscrew the screw on the Call Manager card and remove the card by pulling the
fastening screw.
3. Remove the 2 fastening screws on the 2 premounted spacer sleeves on the IP Me-
dia module.
4. Place the module in the slot and press it down evenly into the slot as far as the stop.
5. Fit the module on to the call manager card from below using the 2 fastening screws.
6. Carefully slide the Call Manager card into the shaft of slot 1 and gently press the
card as far as it goes into the connection on the backplane.
7. Secure the Call Manager card back into its slot with the screw.
8. Restart the call manager by pressing the On/Off button on the call manager card.
Proceed accordingly to fit one or two IP Media modules to a PRI trunk card.
Mitel 470 as of R4.1
syd-0585/1.2 – R4.1 – 08.2016
Installation
109