Mitel 470 System Manual page 226

Operation and Maintenance
Event message
ESME reachable
ESME unreachable
Ethernet activated again
Ethernet deactivated due to
high load
External auxiliary power sup-
ply failed (Mitel 470 only)
External auxiliary power sup-
ply in service (Mitel 470 only)
External event message des-
tination not reachable
External event message des-
tination reachable
Fan failure (Mitel 415/430
only)
226
Trigger condition
The LAN connection between the SMSC and the
ESME is now available
The LAN connection between the SMSC and the
ESME is interrupted
The overload on the Ethernet interface no longer
exists. The interface has been reactivated.
The system has detected an overload on the
Ethernet interface. The interface is temporarily
deactivated.
The external auxiliary power supply to the com-
munication server has failed. If the auxiliary
power supply unit has been used for redundant
operation, there are no short-term limitations. If
the auxiliary power supply unit has been used to
increase the power supply, the internal power
supply unit overflow must be calculated.
The external auxiliary power supply to the com-
munication server is working.
External signal destination not automatically
reachable
External signal destination is now reachable
The fan is jammed or defective or the connection
is no longer making contact.
• Parameter = 0: No more fans in operation.
→ Risk of overheating: Replace defective fan.
1)
Details Severity
IP address, date, critical
time (positive,
with
match)
IP address, date, critical
time (negative,
with
match)
Date, time Normal
(positive,
with
match)
Date, time Normal
(negative,
with
match)
Date, time Normal
(negative,
with
match)
Date, time Normal
(positive,
with
match)
Cause (0: Busy Serious
/1: Not available (negative,
/2:(not used), with
2: Barred /3: not match)
defined), date, time
Date, time Serious
(positive,
with
match)
Parameter, date, critical
time (negative,
with
match)
Mitel 470 as of R4.1
syd-0585/1.2 – R4.1 – 08.2016