Mitel 470 System Manual page 158

Installation
mains available after a first start. This means that the communication server remains
accessible via Ethernet interface in the same way as before the first start.
If no IP addressing is entered on the EIM card (e.g. after initial delivery), the communi-
cation server is started with DHCP after a first start. The communication server tries to
log on with the DHCP server and to enter its host name on the DNS server. If logon is
successful the communication server is accessible via the host name.
If the communication server cannot find a DHCP server within 90 seconds, it deacti-
vates the DHCP mode and is then accessible via the standard IP address (see
Tab. 76) with a direct connection.
Note:
DHCP is deactivated only temporarily and is reactivated after a subsequent restart.
Cable types
The Ethernet switch on the communications server features Auto MDI/MDIX. With the
automatic detection straight or crossover LAN cables can be used for all connection
types.
Configuration
The Ethernet interfaces routed to the front panel can be configured individually in the
IP addressing ( =9g) view. In addition to Auto modes, manual settings are also possi-
ble for Speed and MDI
Status LED
The status of the Ethernet interfaces is indicated by the green and yellow LEDs directly
on the interface in question.
Fig. 71 Status LED on the Ethernet interfaces
Tab. 77 Status LED on the Ethernet interfaces
Green LED Yellow LED
On On
flashing flashing
On Off
flashing Off
Off On
Off flashing
158
type.
Speed
10 Mbit/s
10 Mbit/s
100 Mbit/s
100 Mbit/s
1 Gbit/s
1 Gbit/s
State
Port has a connection with the network
Port is receiving or sending data
Port has a connection with the network
Port is receiving or sending data
Port has a connection with the network
Port is receiving or sending data
syd-0585/1.2 – R4.1 – 08.2016
Mitel 470 as of R4.1