System Reset - Mitel 470 System Manual

5. 6. 3

System reset

Restart of the communication server
A restart reboots the entire communication system. The configuration data is pre-
served.
A new start can be achieved in the following ways:
• Using the control panel on the front panel
See "Call-Manager display and control panel", page 216
• With WebAdmin in the maintenance settings
With the Restart
Notes:
– Never disconnect the communication server from the power supply to trigger a restart. This
can result in data losses and prevent a restart.
– The restart is triggered immediately. All the active call and data connections are interrupted.
First start of the communication server
A first start has the effect of resetting the communication server from scratch. The sys-
tem-specific data such as the system ID, system type, sales channel, licence code,
software generation and IP address of the system are preserved.
A restart can be achieved in the following ways:
• Using the control panel on the front panel
See "Call-Manager display and control panel", page 216
• With WebAdmin in the maintenance settings
With the First start
Notes:
– A first start deletes all the configuration data already stored and replaces it with the default
values of the sales channel. Therefore, back up your configuration data before a first start.
– The first start is triggered immediately. All the active call and data connections are inter-
rupted.
Starting the communication server for the first time and resetting the sales chan-
nel
With the First start and reset sales channel
WebAdmin System reset
delete the sales channel and licence code. During the next start, you will be prompted
for the sales channel and licence code. Note that the licence code is dependent on the
sales channel and that you can no longer use the existing licence code.
Note:
This function is only accessible for Administrators in Expert mode.
Mitel 470 as of R4.1
syd-0585/1.2 – R4.1 – 08.2016
button in the System
button in the System reset
( =4e) view, you have the possibility for a first start to also
reset( =4e) view.
( =4e) view.
button for the maintenance settings in the
Configuration
191