Fitting Ip Media Modules - Mitel Aastra 470 System Manual

Installation
To fit a DSP module, proceed as follows:
Warning
Be sure to observe the
1. Shut down the call manager via the control panel (see
2. Unscrew the screw on the Call Manager card and remove the card by pulling the
fastening screw.
3. Remove the fastening screw on the module slot for DSP modules.
4. The spacer sleeve for the lower module is already premounted on the processor
card. For the upper DSP module screw the spacer sleeve supplied with the mod-
ule into place.
5. Place the module on slot (or onto a module already fitted in that slot) and press
down evenly on both connectors as far as the stop.
6. Secure the module with the fastening screw.
7. Carefully slide the Call Manager card into the shaft of slot 1 and gently press the
card as far as it goes into the connection on the backplane.
8. Secure the Call Manager card back into its slot with the screw.
9. Restart the call manager by pressing the On/Off button on the call manager
card.
4. 5. 6

Fitting IP Media modules

IP Media modules are fitted either to the Call Manager card or to PRI trunk cards. IP
Media modules are
To fit an IP Media module to a Call Manager card, proceed as follows:
Warning
Be sure to observe the
1. Shut down the call manager via the control panel (see
2. Unscrew the screw on the Call Manager card and remove the card by pulling the
fastening screw.
3. Remove the 2 fastening screws on the 2 premounted spacer sleeves on the IP
Media module.
4. Place the module in the slot and press it down evenly into the slot as far as the
stop.
108
"Safety regulations", page
not stackable.
"Safety regulations", page
92.
"On/Off key", page 225).
92.
"On/Off key", page 225).
Aastra 470 as of R3.2
syd-0337/1.6 – R3.2 – 09.2014