Connecting The Uv 105 Power Supply Unit - HEIDENHAIN TNC 410 M Technical Manual

6.8 Connecting the UV 105 Power Supply Unit

X69, X169: NC
supply voltage and
control signals
6 – 72
Note
For the control to be able to evaluate the status signals of the power supply
units, connector X69 of the controller unit must be connected by ribbon
cable with X69 of the UV 105.
Since non-HEIDENHAIN inverters do not send any status signals, an
adapter connector (Id. Nr. 349 211-01) must be connected to X69 on the
UV 105. This connector is delivered with the UV 105.
Note
There is no need for the UV 105 power supply unit when the UV 1x0D is
used. If the UV 1x0 or UE 2xxB is used, the power supplied by the power
pack does not suffice. In this case an UV 105 must be used.
Warning
See also the information on Page 4–37 and the following pages about the
connection of the UV 105.
Connection:
50-pin ribbon Assignment
connector
1a to 5b +5 V
6a to 7b +12 V
8a +5 V (low-voltage
separation)
8b 0 V (low-voltage
separation)
9a +15 V
9b –15 V
10a UZAN
10b 0 V
11a IZAN
11b 0 V
12a RES.PS
12b 0 V
HEIDENHAIN Technical Manual for Inverter Systems and Motors
50-pin ribbon Assignment
connector
16b GND
17a RDY.PS
17b GND
18a ERR.ILEAK
18b GND
19a PF.PS.AC (only
UV(R) 120(D),
UVR 130D,
UV 130D,
UV(R) 140(D),
UV(R) 150(D),
UVR 160D(W),
UR 2xx)
19b GND
20a Do not assign
20b GND
21a Do not assign
21b GND
22a Do not assign