Connecting The Uv 105 Power Supply Unit - HEIDENHAIN TNC 410 M Technical Manual

5.7 Connecting the UV 105 Power Supply Unit

X69, X169: NC
supply voltage and
control signals
X74: 5-V connection
of the UV 105
April 2007
Note
For the control to be able to evaluate the status signals of the power supply
units, connector X69 of the controller unit must be connected by ribbon
cable with X69 of the UV 105.
Since non-HEIDENHAIN inverters do not send any status signals, an
adapter connector (Id. Nr. 349 211-01) must be connected to X69 on the
UV 105. This connector is delivered with the UV 105.
Connection:
50-pin ribbon Assignment
connector
1a to 5b +5 V
6a to 7b +12 V
8a +5 V (low-voltage
separation)
8b 0 V (low-voltage
separation)
9a +15 V
9b –15 V
10a UZAN
10b 0 V
11a IZAN
11b 0 V
12a RES.PS
12b 0 V
13a PF.PS.ZK
13b GND
14a ERR.UZ.GR
14b GND
15a ERR.IZ.GR
15b GND
16a ERR.TMP
Connection:
Wire color of 5-V connection
Black
Red
Connecting the UV 105 Power Supply Unit
50-pin ribbon Assignment
connector
16b GND
17a RDY.PS
17b GND
18a ERR.ILEAK
18b GND
19a PF.PS.AC (only
UV 120, UV 140,
UV 150, UR 2xx)
19b GND
20a Do not assign
20b GND
21a Do not assign
21b GND
22a Do not assign
22b GND
23a Reserved (SDA)
23b GND
24a Reserved (SLC)
24b GND
25a RES.LE
25b GND
5-V terminal on CC 42x
0 V
+5 V
5 – 65