HEIDENHAIN TNC 410 M Technical Manual page 11

1 Update Information No. 4
1.1 General Information
1.2 Modular Inverter
1.3 Motors
March 2003
New axis-enabling module (Id. Nr. 341 518-01) that allows you to switch off
power modules in modular inverter systems group-by-group. The axis-
enabling module is mounted onto the power module and separates the unit
bus. All power modules that are connected after the axis-enabling module
to the unit bus are switched of via X72 of the unit bus, and no longer via X72
of the UV(R) 1x0.
New variant of the UV 140 power supply unit (Id. Nr. 335 009-04) with
improved PCB and improved housing.
New UVR 150 power supply unit (Id. Nr. 384 708-01) with new power supply
unit and additional connections for supplying the CC 42x with +5 V and 0 V.
New QSY 116J EcoDyn, QSY 155B EcoDyn, QSY 155C EcoDyn, QSY 155F
EcoDyn synchronous motors
The following NC software versions are required for controlling these
motors in the EcoDyn operating mode:
• iTNC 530: 340 420-06 and later
• MANUALplus 4110: 354 809-11 and later
• CNC PILOT 4290: 340 460-14, 362 796-10 and later
Designation
QSY 116J EcoDyn
QSY 116J EcoDyn
QSY 155C EcoDyn
QSY 155C EcoDyn
QSY 155C EcoDyn
New QAN 200M, QAN 200L, QAN 200U asynchronous motors
Designation
QAN 200M
QAN 200M
QAN 200M
Update Information No. 4
Stall torque M
0
10.0 Nm
13.0 Nm
17.7 Nm
21.6 Nm
26.1 Nm
Rated speed n
N
1500 rpm
1500 rpm
1500 rpm
Rated speed n
N
3000 rpm
3000 rpm
3000 rpm
3000 rpm
3000 rpm
Rated power output P
5.5 kW
7.5 kW
10 kW
N
1 – 1