6.3 Double-Row Configuration
6 – 52
Double-row configuration can be used when there is not enough space for
arranging the modules in one row.
1: Unit bus cable (round)
2: Extreme left connector of flat unit bus cable. This connector is used to
connect the two rows with each other via the round unit bus cable.
3: Unit bus cable (flat)
4: Supply bus cable (round)
5: PWM cable
6: Installation kit
Warning
Due to the heat generated by the inverter components, the separation
between the two rows should be at least 250 mm.
See also the information on Page 4–37 and the following pages.
For more information on double-row configuration, see Page 2–99.
HEIDENHAIN Technical Manual for Inverter Systems and Motors