Table of Contents
Advertisement
R0E530640MCU00 User's Manual
5.12.4 Measuring an Address Range
The E100 emulator shows the access information it collected from a user-specified address range.
Figure 5.107 Data Coverage window (address specification)
The Data Coverage window is vertically divided into halves by a splitter.
The upper area shows the address ranges to be measured and access rates.
Table 5.35 Contents in the upper area of Data Coverage window
[Range]
[Access Rate]
The lower area shows detail information of the address range selected in the upper area.
Table 5.36 Contents in the lower area of Data Coverage window
[Address]
[Label]
[Area]
[Data]
If located outside the coverage memory allocated area, address lines are displayed in gray. Although the existing coverage
information of those addresses is retained, updating of coverage information by program execution does not apply.
The acquired coverage information is accumulated in memory until the user clears it.
REJ10J1733-0100 Rev.1.00 Apr. 01, 2008
Page 172 of 229
Address ranges in which coverage is measured
Shows access rates by a percentage and graph
Address value
Label name
Memory area (FlashROM, RAM, SFR)
This column is blank for unused areas.
Memory data
The accessed data has its background displayed in purple.
5. Debugging Functions
Advertisement
Table of Contents
