Showing The Trace Information Acquired By Fill Around Tp - Renesas M16C/64 User Manual

R0E530640MCU00 User's Manual 3. Tutorial

3.17.2 Showing the Trace Information Acquired by Fill around TP

The point & delay facility stops acquiring trace information a specified number of cycles after a trace point is encountered.
This facility allows you to keep track of program flow from trace information without having to break the user program.
(1) If any break conditions are set, clear all of them.
(2) Choose Fill around TP for trace mode in the Trace conditions dialog box. In the Delay Value (Cycles) column, specify 4M.
(Up to 4M cycles of trace information from where a trace point is encountered will be acquired.)
Figure 3.34 Trace conditions dialog box (Fill around TP)
REJ10J1733-0100 Rev.1.00 Apr. 01, 2008
Page 59 of 229