Table of Contents
Advertisement
R0E530640MCU00 User's Manual
5. Debugging Functions
Click the Add button, and the Add Coverage Files dialog box shown below will be displayed.
Figure 5.98 Add Coverage Files dialog box
Use this dialog box to enter a coverage information file you want to load. You can specify a load mode and offset for each file
you load.
Only the files bearing the extension ".cov" can be loaded. If you enter any other file extension, an error message is output.
The files you added are listed in the Load Coverage Data dialog box.
The files are loaded in the order in which they are listed. If necessary, use the Up or Down button to change the order.
CAUTION
If the coverage information file you are loading is of a source file specification type, you cannot specify an offset when you
load.
5.11.19 About Coverage Information File Load Modes
Coverage information file load modes are schematically shown below.
(1) When selecting Overwrite
Figure 5.99 Schematic of load modes when selecting overwrite
REJ10J1733-0100 Rev.1.00 Apr. 01, 2008
Page 166 of 229
Advertisement
Table of Contents
